 |
1231 Alliance Blvd |
||||||||
| This is a J.C. Ford Sheeter / Toasting oven's controls before I made over. | |||||||||
 |
  |
||||||||
| This is after. New electric ignition and flame control system by 
installed. Flame control uses a UV Scanner for flame detection for increased safety. |
|||||||||
| This is a EFM Mixer before. | |||||||||
 |
 |
||||||||
| This is the same Mixer after replacing some of the controls. | |||||||||
 |
 |
||||||||
| The owner did not want to
replace the existing control cabinet, so a fresh coat of
epoxy enamel was sprayed over the exterior. The interior rust was cleaned and primed. New door seals were also installed. The buttons, selector switches and E-Stop were replaced with new Cutler - Hammer parts. The old Allen Bradley motor starters were replaced with Fuji contactors with a mechanical reverse lockout. All these parts came from Automation Direct at a considerable savings over other suppliers. |
|||||||||
 |
 |
||||||||
| This was a control panel for a Oddy Dough Divider. A machine that makes dough balls that are used to make tortillas. | |||||||||